314
mirroring-group reflector-port
Use mirroring-group reflector-port to configure the reflector port for a remote source group.
Use undo mirroring-group reflector-port to restore the default.
Syntax
In system view:
mirroring-group group-id reflector-port interface-type interface-number
undo mirroring-group group-id reflector-port interface-type interface-number
In interface view:
mirroring-group group-id reflector-port
undo mirroring-group group-id reflector-port
Default
No reflector port is configured for a mirroring group.
Views
System view
Interface view
Predefined user roles
network-admin
Parameters
group-id: Specifies a mirroring group by its number. The specified mirroring group must already exist.
The value range for this argument is 1 to 4.
interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
You can configure reflector ports only for remote source groups.
The port to be configured as a reflector port must be a port not in use. Do not connect a network
cable to a reflector port.
When a port is configured as a reflector port, the port restores to the factory default settings. You
cannot configure other features on a reflector port.
If an IRF port is bound to only one physical interface, do not configure the physical interface as a
reflector port. Otherwise, the IRF might split.
You cannot change the duplex mode, MDI settings, or speed for a reflector port.
The member port of an aggregate interface can be configured as a reflector port.
Examples
# Create remote source group 1. Configure GigabitEthernet 1/0/1 as its reflector port in system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port gigabitethernet 1/0/1
This operation may delete all settings made on the interface. Continue? [Y/N]: y
# Create remote source group 2. Configure GigabitEthernet 1/0/2 as its reflector port in interface
view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
To Next Page
Loading...
Need help?
General