315
[Sysname] interface gigabitethernet 1/0/2
[Sysname-GigabitEthernet1/0/2] mirroring-group 2 reflector-port
This operation may delete all settings made on the interface. Continue? [Y/N]: y
Related commands
mirroring-group
mirroring-group remote-probe vlan
Use mirroring-group remote-probe vlan to specify a VLAN as the remote probe VLAN for a
mirroring group.
Use undo mirroring-group remote-probe vlan to restore the default.
Syntax
mirroring-group group-id remote-probe vlan vlan-id
undo mirroring-group group-id remote-probe vlan vlan-id
Default
No remote probe VLAN is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
Parameters
group-id: Specifies a mirroring group by its number. The specified mirroring group must already exist.
The value range for this argument is 1 to 4.
vlan-id: Specifies a VLAN by its ID.
Usage guidelines
You can configure remote probe VLANs only for remote source groups and remote destination
groups.
When a VLAN is configured as a remote probe VLAN, use the VLAN for port mirroring exclusively.
The remote mirroring groups on the source device and destination device must use the same remote
probe VLAN.
Only a static VLAN that already exists can be configured as a remote probe VLAN. A VLAN can be
configured as the remote probe VLAN for only one mirroring group.
To delete a VLAN that is configured as a remote probe VLAN, remove the remote probe VLAN
configuration first.
Examples
# Create remote source group 1 and configure VLAN 10 as its remote probe VLAN.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 remote-probe vlan 10
# Create remote destination group 2 and configure VLAN 20 as its remote probe VLAN.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-destination
[Sysname] mirroring-group 2 remote-probe vlan 20
To Next Page
Loading...
Need help?
General