HPE FlexNetwork 5130 HI SERIES User Manual

70
The following parameters are not available for the UDP tracert operation:
• The probe-failure consecutive-probe-failures option.
• The accumulate-probe-failures argument.
Examples
# Configure the system to send a trap if five or more consecutive probe failures occur in an ICMP
echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction trap probe-failure 5
reaction trigger per-probe
Use reaction trigger per-probe to configure the probe result sending on a per-probe basis.
Use undo reaction trigger per-probe to restore the default.
Syntax
reaction trigger per-probe
undo reaction trigger per-probe
Default
The probe result is sent to the feature that uses the template after three consecutive failed or
successful probes.
Views
ICMP/TCP half open template view
Predefined user roles
network-admin
Usage guidelines
The feature enables the NQA client to send the probe result to the feature that uses the NQA
template every time a probe is completed.
If you execute this command and the reaction trigger probe-fail command multiple times, the most
recent configuration takes effect.
If you execute this command and the reaction trigger probe-pass command multiple times, the
most recent configuration takes effect.
Examples
# In ICMP template view, configure the probe result sending on a per-probe basis.
<Sysname> system-view
[Sysname] nqa template icmp icmptplt
[Sysname-nqatplt-icmp-icmptplt] reaction trigger per-probe
Related commands
reaction trigger probe-fail
reaction trigger probe-pass

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English