HPE FlexNetwork 5130 HI SERIES User Manual

184
Predefined user roles
network-admin
Parameters
all: Specifies SNMPv1, SNMPv2c, and SNMPv3.
v1: Specifies SNMPv1.
v2c: Specifies SNMPv2c.
v3: Specifies SNMPv3.
Usage guidelines
SNMPv1 and SNMPv2c settings in this command are not supported in FIPS mode.
Configure the SNMP agent with the same SNMP version as the NMS for successful communications
between them.
Examples
# Enable SNMPv3.
<Sysname> system-view
[Sysname] snmp-agent sys-info version v3
Related commands
display snmp-agent sys-info
snmp-agent target-host
Use snmp-agent target-host to configure an SNMP notification target host.
Use undo snmp-agent target-host to remove an SNMP notification target host.
Syntax
In non-FIPS mode:
snmp-agent target-host inform address udp-domain { ipv4-address | ipv6 ipv6-address }
[ udp-port port-number ] params securityname security-string { v2c | v3 [ authentication |
privacy ] }
snmp-agent target-host trap address udp-domain { ipv4-address | ipv6 ipv6-address } [ udp-port
port-number ] params securityname security-string [ v1 | v2c | v3 [ authentication | privacy ] ]
undo snmp-agent target-host { trap | inform } address udp-domain { ipv4-address | ipv6
ipv6-address } params securityname security-string
In FIPS mode:
snmp-agent target-host inform address udp-do
main {
ipv4-address | ipv6 ipv6-address }
[ udp-port port-number ] params securityname security-string v3 { authentication | privacy }
snmp-agent target-host trap address udp-domain { ipv4-address | ipv6 ipv6-address } [ udp-port
port-number ] params securityname security-string v3 { authentication | privacy }
undo snmp-agent target-host { trap | inform } address udp-domain { ipv4-address | ipv6
ipv6-address } params securityname security-string
Default
No SNMP notification target hosts exist.
Views
System view

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English