240
action reboot
Use action reboot to add a reboot action to a monitor policy.
Use undo action to remove an action.
Syntax
action number reboot [ slot slot-number ]
undo action number
Default
A monitor policy does not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, the command reboots the IRF fabric.
Usage guidelines
The reboot action configured with this command reboots devices or cards without saving the running
configuration. If you want to save the running configuration, use the action cli command to configure
reboot actions.
You can configure a series of actions to be executed in response to the event specified in a monitor
policy. EAA executes the actions in ascending order of action IDs. When you add actions to a policy,
you must make sure the execution order is correct. If two actions have the same ID, the most recent
one takes effect.
When you define an action, you can specify a value or specify a variable name for an argument. For
more information about using EAA environment variables, see "rtm environment."
Examples
# Configure an action for the CLI-defined policy test to reboot the specified slot.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 reboot slot 1
action switchover
Use action switchover to add an active/standby switchover action to a monitor policy.
Use undo action to remove an action.
Syntax
action number switchover
undo action number
Default
A monitor policy does not contain any actions.
To Next Page
Loading...
Need help?
General