354
Syntax
terminal debugging
undo terminal debugging
Default
Display of debug information is disabled on the current terminal.
Views
User view
Predefined user roles
network-admin
Usage guidelines
To enable display of debug information on the console, perform the following tasks:
1. Execute the terminal debugging command.
2. Enable the information center. The information center is enabled by default.
3. Use a debugging command to enable the related debugging.
To enable display of debug information on the current terminal, perform the following tasks:
1. Execute the terminal monitor and terminal debugging commands.
2. Enable the information center. The information center is enabled by default.
3. Use a debugging command to enable the related debugging.
This command takes effect only for the current connection between the terminal and the device. If a
new connection is established, the default is restored.
You can also enable display of debug information on the current terminal by executing the terminal
logging level 7 command. This command has the following differences from the terminal
debugging command:
• The terminal logging level 7 command enables log display for all levels (levels 0 through 7) on
the current terminal.
• The terminal debugging command only enables display of logs with the following severity
levels:
{ Debug level (level 7).
{ Severity level higher than or equal to the level specified in the terminal logging level
command.
Examples
# Enable display of debug information on the current terminal.
<Sysname> terminal debugging
The current terminal is enabled to display debugging information.
Related commands
terminal logging level
terminal monitor
terminal logging level
Use terminal logging level to set the lowest level of logs that can be output to the current terminal.
Use undo terminal logging level to restore the default.
To Next Page
Loading...
Need help?
General