Need help?Do you have a question about the HPE FlexNetwork 5130 EI Series and is the answer not in the manual?
Configures common parameters for Ethernet interfaces, including bandwidth, description, and speed settings.
Manages Layer 2 specific features for Ethernet interfaces, such as storm control and MAC address handling.
Displays MAC address entries, supporting filtering by address, VLAN, state, and interface.
Manages the global and per-interface MAC address learning status and configuration.
Configures Ethernet link aggregation, including bandwidth, default settings, and interface descriptions.
Configures LACP parameters such as system ID, edge ports, mode, period, and selection criteria.
Configures global and group-specific load balancing modes for link aggregation.
Configures MST region parameters, including region name, revision level, and VLAN-to-instance mapping.
Displays STP status, statistics, and port information across different modes (MSTP, PVST).
Configures STP protection features like BPDU guard, root guard, and TC protection.
Configures STP timers such as forward delay, hello time, max age, and timer factor.
Sets the action (block, no-learning, shutdown) taken when a loop is detected on a port.
Configures VLAN assignments for ports, including access, hybrid, and trunk port types.
Configures VLAN assignment based on MAC addresses, including dynamic and static entries.
Manages super VLANs and their associated sub-VLANs for hierarchical VLAN structures.
Configures private VLANs, including primary, secondary, promiscuous, and host ports.
Configures voice VLANs, including MAC address identification, aging, security, and QoS.
To Next Page
General