99
• Source MAC.
• Destination MAC.
• Source IP and destination IP.
• Source MAC and destination MAC.
Examples
# Configure Layer 2 aggregation group 1 to load share packets based on destination MAC
addresses.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation load-sharing mode destination-mac
Related commands
link-aggregation global load-sharing mode
link-aggregation load-sharing mode local-first
Use link-aggregation load-sharing mode local-first to enable local-first load
sharing for link aggregation.
Use undo link-aggregation load-sharing mode local-first to disable local-first load
sharing for link aggregation.
Syntax
link-aggregation load-sharing mode local-first
undo link-aggregation load-sharing mode local-first
Default
Local-first load sharing is enabled for link aggregation.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Use local-first load sharing in a multidevice link aggregation scenario to distribute traffic preferentially
across member ports on the ingress card or device. Local-first load sharing takes effect only on
known unicast traffic.
If you disable local-first load sharing, packets of an aggregate interface are load shared among all
Selected ports on IRF member devices.
Examples
# Disable local-first load sharing for link aggregation.
<Sysname> system-view
[Sysname] undo link-aggregation load-sharing mode local-first
link-aggregation mode
Use link-aggregation mode dynamic to configure an aggregation group to operate in
dynamic aggregation mode and enable LACP.
Use undo link-aggregation mode to restore the default.
To Next Page
Loading...
Need help?
General