105
Port isolation commands
display port-isolate group
Use display port-isolate group to display port isolation group information.
Syntax
display port-isolate group [ group-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group-id: Specifies an isolation group by its ID. The value range is 1 to 8.
Examples
# Display all isolation groups.
<Sysname> display port-isolate group
Port isolation group information:
Group ID: 1
Group members:
GigabitEthernet1/0/1
Group ID: 5
Group members:
GigabitEthernet1/0/2 GigabitEthernet1/0/4
# Display information about isolation group 1.
<Sysname> display port-isolate group 1
Port isolation group information:
Group ID: 1
Group members:
GigabitEthernet1/0/1
Table 23 Command output
Field Description
Group ID ID of the isolation group.
Group members
Isolated ports in the isolation group.
No ports
indicates
that the isolation group contains no isolated ports.
Related commands
port-isolate enable