91
Use undo interface bridge-aggregation to delete a Layer 2 aggregate interface.
Syntax
interface bridge-aggregation interface-number
undo interface bridge-aggregation interface-number
Default
No Layer 2 aggregate interfaces exist.
Views
System view
Predefined user roles
network-admin
Parameters
interface-number: Specifies a Layer 2 aggregate interface number. The value range for the
interface-number argument is 1 to 1024.
Usage guidelines
When you create a Layer 2 aggregate interface, the system automatically creates a Layer 2
aggregation group with the same number. The aggregation group operates in static aggregation
mode by default.
Deleting a Layer 2 aggregate interface also deletes the Layer 2 aggregation group. At the same time,
the member ports of the aggregation group, if any, leave the aggregation group.
Examples
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and enter its view.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]
lacp edge-port
Use lacp edge-port to configure an aggregate interface as an edge aggregate interface.
Use
undo lacp edge-port to restore the default.
Syntax
lacp edge-port
undo lacp edge-port
Default
An aggregate interface does not operate as an edge aggregate interface.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
Use this command on the aggregate interface that connects the device to a server if dynamic link
aggregation is configured only on the device. This feature improves link reliability by enabling all
member ports of the aggregation group to forward packets.
To Next Page
Loading...
Need help?
General