HPE FlexNetwork 5130 EI Series User Manual

143
[Sysname] stp mode stp
Related commands
stp enable
stp global enable
stp global mcheck
stp mcheck
stp vlan enable.
stp no-agreement-check
Use stp no-agreement-check to enable No Agreement Check on a port.
Use
undo stp no-agreement-check to disable No Agreement Check on a port.
Syntax
stp no-agreement-check
undo stp no-agreement-check
Default
No Agreement Check is disabled.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only after you enable it on the root port.
If this command is configured in Layer 2 Ethernet interface view, it takes effect only on that interface.
If this command is configured in Layer 2 aggregate interface view, it takes effect only on the
aggregate interface.
If this command is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Enable No Agreement Check on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp no-agreement-check
stp pathcost-standard
Use stp pathcost-standard to specify a standard for the device to use when calculating the
default path costs for ports.
Use
undo stp pathcost-standard to restore the default.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English