128
Parameters
interface interface-list: Specifies a space-separated list of up to 10 interface items. Each
item specifies an interface or a range of interfaces in the form of
interface-type
interface-number
1 [ to interface-type interface-number 2 ]. The interface
number for
interface-number 2 must be equal to or greater than the interface number for
interface-number 1. If you do not specify this option, this command clears the spanning tree
statistics on all ports.
Examples
# Clear the spanning tree statistics on ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
<Sysname> reset stp interface gigabitethernet 1/0/1 to gigabitethernet 1/0/3
Related commands
display stp
revision-level
Use revision-level to configure the MSTP revision level.
Use
undo revision-level to restore the default MSTP revision level.
Syntax
revision-level level
undo revision-level
Default
The MSTP revision level is 0.
Views
MST region view
Predefined user roles
network-admin
Parameters
level: Specifies an MSTP revision level in the range of 0 to 65535.
Usage guidelines
The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a
device determine the device's MST region.
After configuring this command, execute the
active region-configuration command to
activate the configured MST region level.
Examples
# Set the MSTP revision level of the MST region to 5.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5
Related commands
active region-configuration
check region-configuration
display stp region-configuration
To Next Page
Loading...
