HPE FlexNetwork 5130 EI Series User Manual

155
stp tc-protection threshold
Use stp tc-protection threshold to set the maximum number of forwarding address entry
flushes that the device can perform every 10 seconds.
Use undo stp tc-protection threshold to restore the default.
Syntax
stp tc-protection threshold number
undo stp tc-protection threshold
Default
By default, the device can perform a maximum of 6 forwarding address entry flushes every 10
seconds.
Views
System view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of immediate forwarding address entry flushes that the
device can perform every 10 seconds. The value is in the range of 1 to 255.
Examples
# Configure the device to perform up to 10 forwarding address entry flushes every 10 seconds.
<Sysname> system-view
[Sysname] stp tc-protection threshold 10
Related commands
stp tc-protection
stp tc-restriction
Use stp tc-restriction to enable TC-BPDU transmission restriction.
Use
undo stp tc-restriction to disable TC-BPDU transmission restriction.
Syntax
stp tc-restriction
undo stp tc-restriction
Default
TC-BPDU transmission restriction is disabled.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English