HPE FlexNetwork 5130 EI Series User Manual

248
Parameters
service-tag: Sets the TPID value in the SVLAN tag.
hex-value
: Sets a hexadecimal TPID value in the range of 1 to ffff, excluding the reserved
EtherType values listed in Table 53.
Table 53
Reserved EtherType values
Protocol type Value
ARP 0x0806
PUP 0x0200
RARP 0x8035
IP 0x0800
IPv6 0x86dd
PPPoE 0x8863/0x8864
MPLS 0x8847/0x8848
IPX/SPX 0x8137
IS-IS 0x8000
LACP 0x8809
LLDP 0x88cc
802.1X 0x888e
802.1ag 0x8902
Cluster 0x88a7
Reserved 0xfffd/0xfffe/0xffff
Usage guidelines
A port without QinQ enabled uses the SVLAN TPID to match incoming tagged frames. The port
modifies the TPID in the SVLAN tag of outgoing frames as the configured value.
Examples
# Set the TPID value in SVLAN tags to 9100 (hexadecimal) on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq ethernet-type service-tag 9100
Related commands
qinq ethernet-type (system view)
qinq ethernet-type (system view)
Use qinq ethernet-type to set the TPID value in CVLAN tags.
Use
undo qinq ethernet-type to restore the default TPID value in CVLAN tags.
Syntax
qinq ethernet-type customer-tag hex-value
undo qinq ethernet-type customer-tag

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English