171
# Configure the description of VLAN-interface 2 as linktoPC56.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] quit
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] description linktoPC56
Related commands
display interface vlan-interface
display vlan
display interface vlan-interface
Use display interface vlan-interface to display VLAN interface information.
Syntax
display interface vlan-interface [ interface-number ] [ brief [ description
| down ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vlan-interface interface-number: Specifies a VLAN interface number. If you do not
specify this argument, the command displays information about all VLAN interfaces.
brief: Displays brief interface information. If you do not specify this keyword, the command
displays detailed interface information.
description: Displays complete interface descriptions. If you do not specify this keyword, the
command displays only the first 27 characters of each interface description.
down: Displays VLAN interfaces in down state and their down causes. If you do not specify this
keyword, the command displays information about VLAN interfaces in all states.
Examples
# Display information about VLAN-interface 10.
<Sysname> display interface vlan-interface 10
Vlan-interface10
Current state: UP
Line protocol state: UP
Description: Vlan-interface10 Interface
Bandwidth: 100000 kbps
Maximum transmission unit: 1500
Internet Address is 192.168.1.54/24 Primary
IP packet frame type: Ethernet II, hardware address: 0023-89b6-d613
IPv6 packet frame type: Ethernet II, hardware address: 0023-89b6-d613
Last clearing of counters: Never
# Display brief information about VLAN-interface 2.
To Next Page
Loading...
