HPE FlexNetwork 5130 EI Series User Manual

108
Spanning tree commands
active region-configuration
Use active region-configuration to activate your MST region configuration.
Syntax
active region-configuration
Views
MST region view
Predefined user roles
network-admin
Usage guidelines
When you configure MST region parameters, MSTP launches a new spanning tree calculation
process that might cause network topology instability. This is most likely to occur when you configure
the VLAN-to-instance mapping table. The launch occurs after you execute the
active
region-configuration
command or the stp global enable command.
As a best practice, use the
check region-configuration command to determine whether the
MST region configurations to be activated are correct. Run this command only when they are
correct.
Examples
# Map VLAN 2 to MSTI 1 and activate the MST region configuration.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
[Sysname-mst-region] active region-configuration
Related commands
check region-configuration
instance
region-name
revision-level
stp global enable
vlan-mapping modulo
bpdu-drop any
Use bpdu-drop any to enable BPDU drop on a port.
Use
undo bpdu-drop any to disable BPDU drop on a port.
Syntax
bpdu-drop any
undo bpdu-drop any

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English