241
To keep the dynamic VLANs learned through MVRP stable, do not set the LeaveAll timer less than its
default value.
The device randomly changes the LeaveAll timer within a certain range when an MRP participant
restarts its LeaveAll timer. This prevents the LeaveAll timer of a particular participant from always
expiring first.
Examples
# Set the LeaveAll timer to 1500 centiseconds. (In this example, the Leave timer on each port uses
the default setting.)
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mrp timer leaveall 1500
Related commands
display mvrp running-status
mrp timer leave
mrp timer periodic
Use mrp timer periodic to set the Periodic timer.
Use
undo mrp timer periodic to restore the default.
Syntax
mrp timer periodic timer-value
undo mrp timer periodic
Default
The Periodic timer is 100 centiseconds.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
timer-value: Specifies the Periodic timer, which can be 0 or 100 centiseconds.
Usage guidelines
Setting the Periodic timer to 0 disables the Periodic timer.
Setting the Periodic timer to 100 enables the Periodic timer. The participant then sends MRP frames
at an interval of 100 centiseconds.
Examples
# Disable the Periodic timer.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mrp timer periodic 0
Related commands
display mvrp running-status
To Next Page
Loading...
