230
Usage guidelines
You can manually delete or add the system default OUI addresses.
The device supports a maximum of 128 OUI addresses.
Examples
# Add OUI address 1234-1200-0000 by specifying the MAC address as 1234-1234-1234 and the
mask as fff-ff00-0000. Configure the OUI address description as PhoneA.
<Sysname> system-view
[Sysname] voice-vlan mac-address 1234-1234-1234 mask ffff-ff00-0000 description PhoneA
Related commands
display voice-vlan mac-address
voice-vlan mode auto
Use voice-vlan mode auto to configure a port to operate in automatic voice VLAN assignment
mode.
Use
undo voice-vlan mode auto to configure a port to operate in manual voice VLAN
assignment mode.
Syntax
voice-vlan mode auto
undo voice-vlan mode auto
Default
A port operates in automatic voice VLAN assignment mode.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
To make a voice VLAN take effect on a port operating in manual mode, you must manually assign the
port to the voice VLAN.
Examples
# Configure GigabitEthernet 1/0/1 to operate in manual voice VLAN assignment mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo voice-vlan mode auto
Related commands
display voice-vlan state
voice-vlan qos
Use voice-vlan qos to configure a port to modify the CoS and DSCP values for incoming voice
VLAN packets.
Use undo voice-vlan qos to restore the default.
To Next Page
Loading...
