246
QinQ commands
This document uses the following terms:
• CVLAN—Customer network VLANs, also called inner VLANs, refer to VLANs that a customer
uses on the private network.
• SVLAN—Service provider network VLANs, also called outer VLANs, refer to VLANs that a
service provider uses to transmit VLAN tagged traffic for customers.
display qinq
Use display qinq to display QinQ-enabled interfaces.
Syntax
display qinq [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and
number. If you do not specify an interface, this command displays all QinQ-enabled interfaces.
Usage guidelines
If QinQ is not enabled on any interfaces, this command does not provide any output.
Examples
# Enable QinQ on GigabitEthernet 1/0/1. Then, verify that QinQ is enabled on the interface.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
[Sysname-GigabitEthernet1/0/1] display qinq interface gigabitethernet 1/0/1
Interface
GigabitEthernet1/0/1
# Enable QinQ on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/3. Then, verify that QinQ is enabled
on the interfaces.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/3
[Sysname-GigabitEthernet1/0/3] qinq enable
[Sysname-GigabitEthernet1/0/3] display qinq
Interface
GigabitEthernet1/0/1
GigabitEthernet1/0/3
To Next Page
Loading...
