HPE FlexNetwork 5130 EI Series User Manual

85
Field Description
destination-mac address, source-mac
address
User-configured link-aggregation load sharing mode. In this
sample output, traffic is load shared based on source and
destination MAC addresses.
display link-aggregation member-port
Use display link-aggregation member-port to display detailed link aggregation
information for the specified member ports.
Syntax
display link-aggregation member-port [ interface-list ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-list: Specifies a list of link aggregation member ports, in the format
interface-type interface-number1 [ to interface-type interface-number2 ].
The value for the
interface-number2 argument must be equal to or greater than the value for
the
interface-number1 argument.
Usage guidelines
A member port in a static aggregation group cannot obtain information about the peer group. For
such member ports, the command displays the port number, port priority, and operational key of only
the local end.
Examples
# Display detailed link aggregation information for GigabitEthernet 1/0/1, which is a member port of a
static aggregation group.
<Sysname> display link-aggregation member-port gigabitethernet 1/0/1
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
GigabitEthernet1/0/1:
Aggregate Interface: Bridge-Aggregation1
Port Number: 1
Port Priority: 32768
Oper-Key: 1
# Display detailed link aggregation information for GigabitEthernet 1/0/2, which is a member port of a
dynamic aggregation group.
<Sysname> display link-aggregation member-port gigabitethernet 1/0/2
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English