HPE FlexNetwork 5130 EI Series User Manual

136
Use undo stp enable to disable the spanning tree feature.
Syntax
stp enable
undo stp enable
Default
The spanning tree feature is enabled on all ports.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
When you enable the spanning tree feature, the device operates in STP, RSTP, PVST, or MSTP
mode, depending on the spanning tree mode setting.
When you enable the spanning tree feature, the device dynamically maintains the spanning tree
status of VLANs, based on received configuration BPDUs. When you disable the spanning tree
feature, the device stops maintaining the spanning tree status.
If this command is configured in Layer 2 Ethernet interface view, it takes effect only on that interface.
If this command is configured in Layer 2 aggregate interface view, it takes effect only on the
aggregate interface.
If this command is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# In MSTP mode, disable the spanning tree feature on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
Related commands
stp global enable
stp mode
stp vlan enable
stp global config-digest-snooping
Use stp global config-digest-snooping to enable Digest Snooping globally.
Use
undo stp global config-digest-snooping to disable Digest Snooping globally.
Syntax
stp global config-digest-snooping
undo stp global config-digest-snooping
Default
Digest Snooping is disabled globally.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English