102
link-aggregation selected-port minimum
Use link-aggregation selected-port minimum to set the minimum number of Selected
ports in an aggregation group.
Use undo link-aggregation selected-port minimum to restore the default.
Syntax
link-aggregation selected-port minimum min-number
undo link-aggregation selected-port minimum
Default
The minimum number of Selected ports in an aggregation group is not specified.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
min-number: Specifies the minimum number of Selected ports in an aggregation group required to
bring up the aggregate interface. The value range for this argument is 1 to 8.
Usage guidelines
Executing this command might cause all member ports in the aggregation group to become
Unselected ports.
The minimum number of Selected ports allowed in the aggregation groups must be the same for the
local and peer ends.
Examples
# Set the minimum number of Selected ports to 3 for Layer 2 aggregation group 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3
Related commands
link-aggregation selected-port maximum
port link-aggregation group
Use port link-aggregation group to assign an interface to an aggregation group.
Use
undo port link-aggregation group to remove an interface from the aggregation group
to which it belongs.
Syntax
port link-aggregation group group-id [ force ]
undo port link-aggregation group
Default
An interface does not belong to any aggregation group.
To Next Page
Loading...
Need help?
General