HPE FlexNetwork 5130 EI Series User Manual

83
display lacp system-id
Use display lacp system-id to display the local system ID.
Syntax
display lacp system-id
Views
Any view
Predefined user roles
network-admin
network-operator
Usage guidelines
You can use the lacp system-priority command to change the LACP priority of the local
system. The LACP priority value is specified in decimal format in the
lacp system-priority
command. However, it is displayed in hexadecimal format in the output from the
display lacp
system-id
command.
Examples
# Display the local system ID.
<Sysname> display lacp system-id
Actor System ID: 0x8000, 0000-fc00-6504
Table 18 Command output
Field Description
Actor System ID: 0x8000, 0000-fc00-6504
Local system ID, which contains the system LACP priority
(0x8000 in this sample output) and the system MAC address
(0000-FC00-6504 in this sample output).
Related commands
lacp system-priority
display link-aggregation load-sharing mode
Use display link-aggregation load-sharing mode to display global or group-specific
link-aggregation load sharing modes.
Syntax
display link-aggregation load-sharing mode [ interface
[ bridge-aggregation interface-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
bridge-aggregation: Specifies Layer 2 aggregate interfaces.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English