HPE FlexNetwork 5130 EI Series User Manual

48
Parameters
0: Specifies Null 0.
brief: Displays brief interface information. If you do not specify this keyword, the command
displays detailed interface information.
description: Displays complete interface descriptions. If you do not specify this keyword, the
command displays only the first 27 characters of interface descriptions.
down: Displays information about interfaces in down state and the causes. If you do not specify this
keyword, the command displays information about interfaces in all states.
Usage guidelines
The device has only one null interface Null 0. If you specify the null keyword, the command
displays information about the interface Null 0 regardless of whether you specify the
0 keyword.
Examples
# Display detailed information about Null 0.
<Sysname> display interface null 0
NULL0
Current state: UP
Line protocol state: UP(spoofing)
Description: NULL0 Interface
Bandwidth: 1000000 kbps
Maximum transmission unit: 1500
Internet protocol processing: Disabled
Physical: NULL DEV
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display brief information about Null 0.
<Sysname> display interface null 0 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
NULL0 UP UP(s) --
For the command output, see Table 11 and Table 12.
Related commands
interface null
reset counters interface null
interface loopback
Use interface loopback to create a loopback interface and enter its view, or enter the view of
an existing loopback interface.
Use undo interface loopback to remove a loopback interface.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English