239
Syntax
mrp timer join timer-value
undo mrp timer join
Default
The Join timer is 20 centiseconds.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
timer-value: Specifies the Join timer value (in centiseconds). The Join timer must meet the
following requirements:
• Not less than 20 centiseconds.
• Less than half the Leave timer.
• Divisible by 20 centiseconds.
Examples
# Set the Join timer to 40 centiseconds. (In this example, the Leave timer is 100 centiseconds.)
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mrp timer join 40
Related commands
display mvrp running-status
mrp timer leave
mrp timer leave
Use mrp timer leave to set the Leave timer.
Use
undo mrp timer leave to restore the default.
Syntax
mrp timer leave timer-value
undo mrp timer leave
Default
The Leave timer is 60 centiseconds.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General