HPE FlexNetwork 5130 EI Series User Manual

100
Syntax
link-aggregation mode dynamic
undo link-aggregation mode
Default
An aggregation group operates in static aggregation mode.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Examples
# Configure Layer 2 aggregation group 1 to operate in dynamic aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
link-aggregation port-priority
Use link-aggregation port-priority to set the port priority of an interface.
Use
undo link-aggregation port-priority to restore the default.
Syntax
link-aggregation port-priority priority
undo link-aggregation port-priority
Default
The port priority of an interface is 32768.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
priority: Specifies the port priority in the range of 0 to 65535. The smaller the value, the higher
the port priority.
Examples
# Set the port priority to 64 for Layer 2 Ethernet interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] link-aggregation port-priority 64
Related commands
lacp system-priority

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English