184
untagged: Configures the port as an untagged member of the specified VLANs. An untagged
member of a VLAN sends packets from the VLAN after removing VLAN tags.
Usage guidelines
A hybrid port can allow multiple VLANs. If you execute this command multiple times on a hybrid port,
the hybrid port allows all the specified VLANs.
Examples
# Configure GigabitEthernet 1/0/1 as a hybrid port, and assign it to VLAN 2, VLAN 4, and VLAN 50
through VLAN 100 as a tagged member.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type hybrid
[Sysname-GigabitEthernet1/0/1] port hybrid vlan 2 4 50 to 100 tagged
Related commands
port link-type
port link-type
Use port link-type to set the link type of a port.
Use
undo port link-type to restore the default link type of a port.
Syntax
port link-type { access | hybrid | trunk }
undo port link-type
Default
Each port is an access port.
Views
Layer 2 aggregate interface view
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
access: Sets the port link type to access.
hybrid: Sets the port link type to hybrid.
trunk: Sets the port link type to trunk.
Usage guidelines
To change the link type of a port from trunk to hybrid or vice versa, first set the link type to access.
Examples
# Configure GigabitEthernet 1/0/1 as a trunk port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
To Next Page
Loading...
