285
lldp management-address-format string
Use lldp management-address-format string to set the encoding format of the
management address to string.
Use undo lldp management-address-format to restore the default.
Syntax
In Layer 2 Ethernet interface view:
lldp [ agent { nearest-customer | nearest-nontpmr } ]
management-address-format string
undo lldp [ agent { nearest-customer | nearest-nontpmr } ]
management-address-format
In Layer 2 aggregate interface view:
lldp agent { nearest-customer | nearest-nontpmr }
management-address-format string
undo lldp agent { nearest-customer | nearest-nontpmr }
management-address-format
Default
The encoding format of the management address is numeric.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
agent: Specifies an LLDP agent type. If you do not specify an agent type in Ethernet interface view,
the command sets the encoding format of the management address for nearest bridge agents.
nearest-customer: Specifies nearest customer bridge agents.
nearest-nontpmr: Specifies nearest non-TPMR bridge agents.
Usage guidelines
LLDP neighbors must use the same encoding format for the management address.
The device supports only the numeric encoding format for IPv6 management addresses.
Examples
# Set the encoding format of the management address to string for the nearest customer bridge
agents on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp agent nearest-customer management-address-format
string
lldp max-credit
Use lldp max-credit to set the token bucket size for sending LLDP frames.
To Next Page
Loading...
Need help?
General