HPE FlexNetwork 5130 EI Series User Manual

52
Bulk interface configuration commands
display interface range
Use display interface range to display information about named interface ranges created by
using the
interface range name command.
Syntax
display interface range [ name name ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
name name: Specifies an interface range by its name, a case-sensitive string of 1 to 32 characters.
If you do not specify an interface range name, this command displays information about all interface
ranges created by using the
interface range name command.
Examples
# Display information about the interface ranges created by using the interface range name
command.
<Sysname> display interface range
Interface range name t2 GigabitEthernet1/0/1 GigabitEthernet1/0/2
Interface range name test GigabitEthernet1/0/3 GigabitEthernet1/0/4
The output shows the following:
• Interfaces GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 are added to interface range
t2.
• Interfaces GigabitEthernet 1/0/3 and GigabitEthernet 1/0/4 are added to interface range
test.
Related commands
interface range name
interface range
Use interface range to create an interface range and enter the interface range view.
Syntax
interface range interface-list
Views
System view
Predefined user roles
network-admin
Parameters
interface-list: Specifies a space-separated list of up to 24 interface items. Each item specifies
an interface by its type and number or specifies a subrange of interfaces in the form of

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English