78
Ethernet link aggregation commands
bandwidth
Use bandwidth to set the expected bandwidth for an interface.
Use
undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) is the interface baud rate divided by 1000.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth is an informational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
Examples
# Set the expected bandwidth to 10000 kbps for Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] bandwidth 10000
default
Use default to restore the default settings for an aggregate interface.
Syntax
default
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of
the impacts of this command when you execute it on a live network.
To Next Page
Loading...
