183
Usage guidelines
You can use a nonexistent VLAN as the PVID of a hybrid port. When you delete the PVID of a hybrid
port by using the
undo vlan command, the PVID setting of the port does not change.
For correct packet transmission, set the same PVID for a local hybrid port and its peer.
To enable a hybrid port to transmit packets from its PVID, you must assign the hybrid port to the PVID
by using the
port hybrid vlan command.
Examples
# Configure GigabitEthernet 1/0/1 as a hybrid port, set its PVID to VLAN 100, and assign it to VLAN
100 as an untagged member.
<Sysname> system-view
[Sysname] vlan 100
[Sysname-vlan100] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type hybrid
[Sysname-GigabitEthernet1/0/1] port hybrid pvid vlan 100
[Sysname-GigabitEthernet1/0/1] port hybrid vlan 100 untagged
Related commands
port hybrid vlan
port link-type
port hybrid vlan
Use port hybrid vlan to assign a hybrid port to the specified VLANs.
Use
undo port hybrid vlan to remove a hybrid port from the specified VLANs.
Syntax
port hybrid vlan vlan-id-list { tagged | untagged }
undo port hybrid vlan vlan-id-list
Default
A hybrid port is an untagged member of the VLAN to which the port belongs when its link type is
access.
Views
Layer 2 aggregate interface view
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
vlan-id-list: Specifies a space-separated list of up to 32 VLAN items. Each item specifies a
VLAN ID or a range of VLAN IDs in the form of vlan-id1 to vlan-id2. The value range for VLAN IDs is
1 to 4094. The value for the
vlan-id2 argument must be equal to or greater than the value for the
vlan-id1 argument. The specified VLANs must already exist on the device.
tagged: Configures the port as a tagged member of the specified VLANs. A tagged member of a
VLAN sends packets from the VLAN without removing VLAN tags.
To Next Page
Loading...
Need help?
General