HPE FlexNetwork 5130 EI Series - L2 PT Commands; Displaying L2 Protocol Statistics

287
The bridge mode configuration takes effect only when LLDP is enabled globally. If LLDP is disabled
globally, LLDP can only operate in customer bridge mode.
Examples
# Configure LLDP to operate in service bridge mode.
<Sysname> system-view
[Sysname] lldp mode service-bridge
Related commands
lldp global enable
lldp notification med-topology-change enable
Use lldp notification med-topology-change enable to enable LLDP-MED trapping.
Use
undo lldp notification med-topology-change enable to disable LLDP-MED
trapping.
Syntax
lldp notification med-topology-change enable
undo lldp notification med-topology-change enable
Default
LLDP-MED trapping is disabled.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Examples
# Enable LLDP-MED trapping on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp notification med-topology-change enable
lldp notification remote-change enable
Use lldp notification remote-change enable to enable LLDP trapping.
Use
undo lldp notification remote-change enable to disable LLDP trapping.
Syntax
In Layer 2 Ethernet interface view:
lldp [ agent { nearest-customer | nearest-nontpmr } ] notification
remote-change enable
undo lldp [ agent { nearest-customer
| nearest-nontpmr } ] notification
remote-change enable
In Layer 2 aggregate interface view:
lldp agent { nearest-customer | nearest-nontpmr } notification
remote-change enable