HPE FlexNetwork 5130 EI Series User Manual

109
Default
BPDU drop is disabled on a port.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Examples
# Enable BPDU drop on port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] bpdu-drop any
check region-configuration
Use check region-configuration to display MST region pre-configuration information.
Syntax
check region-configuration
Views
MST region view
Predefined user roles
network-admin
Usage guidelines
Spanning tree devices belong to the same MST region only when they are connected through a
physical link and configured with the same details as follows:
• Format selector (0 by default and not configurable).
• MST region name.
• MST region revision level.
• VLAN-to-instance mapping entries in the MST region.
As a best practice, use this command to determine whether the MST region configurations to be
activated are correct. Activate them only when they are correct.
Examples
# Display MST region pre-configurations.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] check region-configuration
Admin Configuration
Format selector : 0
Region name : 001122334400
Revision level : 0
Configuration digest : 0x3ab68794d602fdf43b21c0b37ac3bca8
Instance VLANs Mapped
0 1, 3 to 4094

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English