HPE FlexNetwork 5130 EI Series - Mac-Address Static Source-Check Enable; Mac-Address Timer

71
If you set the suppression interval or suppression threshold multiple times, the most recent
configuration applies. The suppression interval setting is independent of the suppression threshold
setting.
Examples
# Set the suppression interval to 40 seconds and the suppression threshold to 1 for MAC address
moves.
<Sysname> system-view
[Sysname] mac-address notification mac-move suppression interval 40
[Sysname] mac-address notification mac-move suppression threshold 1
Related commands
mac-address notification mac-move suppression (interface view)
mac-address static source-check enable
Use mac-address static source-check enable to enable the static source check feature.
Use
undo mac-address static source-check enable to disable the static source check
feature.
Syntax
mac-address static source-check enable
undo mac-address static source-check enable
Default
The static source check feature is enabled.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
IRF physical interface view
Predefined user roles
network-admin
Examples
# Disable the static source check feature on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo mac-address static source-check enable
mac-address timer
Use mac-address timer to set the aging timer for dynamic MAC address entries.
Use
undo mac-address timer to restore the default.
Syntax
mac-address timer { aging seconds | no-aging }
undo mac-address timer