288
undo lldp agent { nearest-customer | nearest-nontpmr } notification
remote-change enable
In IRF physical interface view:
lldp notification remote-change enable
undo lldp notification remote-change enable
Default
LLDP trapping is disabled.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
IRF physical interface view
Predefined user roles
network-admin
Parameters
agent: Specifies an LLDP agent type. If you do not specify an agent type in Ethernet interface view,
the command enables LLDP trapping for nearest bridge agents.
nearest-customer: Specifies nearest customer bridge agents.
nearest-nontpmr: Specifies nearest non-TPMR bridge agents.
Examples
# Enable LLDP trapping for the nearest customer bridge agent on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp agent nearest-customer notification remote-change
enable
lldp timer fast-interval
Use lldp timer fast-interval to set an interval for fast LLDP frame transmission.
Use
undo lldp timer fast-interval to restore the default.
Syntax
lldp timer fast-interval interval
undo lldp timer fast-interval
Default
The interval for fast LLDP frame transmission is 1 second.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Sets an interval for fast LLDP frame transmission, in the range of 1 to 3600 seconds.
To Next Page
Loading...
