41
Loopback, null, and inloopback interface
commands
bandwidth
Use bandwidth to set the expected bandwidth for an interface.
Use
undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth of a loopback interface is 0 kbps.
Views
Loopback interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth is an informational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
Examples
# Set the expected bandwidth of Loopback 1 to 1000 kbps.
<Sysname> system-view
[Sysname] interface loopback 1
[Sysname-LoopBack1] bandwidth 1000
default
Use default to restore the default settings for an interface.
Syntax
default
Views
Loopback interface view
Null interface view
Predefined user roles
network-admin
To Next Page
Loading...
