132
If this command is configured in Layer 2 aggregate interface view, it takes effect only on the
aggregate interface.
If this command is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Configure GigabitEthernet 1/0/1 to send only standard-format (802.1s) MSTP packets.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp compliance dot1s
stp config-digest-snooping
Use stp config-digest-snooping to enable Digest Snooping.
Use
undo stp config-digest-snooping to disable Digest Snooping.
Syntax
stp config-digest-snooping
undo stp config-digest-snooping
Default
Digest Snooping is disabled.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
For Digest Snooping to take effect, you must enable Digest Snooping both globally and on
associated ports. As a best practice, first enable Digest Snooping on ports connected to third-party
vendor devices and then enable the feature globally. Digest Snooping takes effect on the ports
simultaneously, which reduces impact on the network.
If this command is configured in Layer 2 Ethernet interface view, it takes effect only on that interface.
If this command is configured in Layer 2 aggregate interface view, it takes effect only on the
aggregate interface.
If this command is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Enable Digest Snooping on GigabitEthernet 1/0/1 and then globally.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp config-digest-snooping
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] stp global config-digest-snooping
Related commands
display stp
To Next Page
Loading...
