HPE FlexNetwork 5130 EI Series User Manual

186
Default
The PVID of a trunk port is VLAN 1.
Views
Layer 2 aggregate interface view
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies a VLAN by its ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a trunk port. When you delete the PVID of a trunk
port by using the
undo vlan command, the PVID setting of the port does not change.
For correct packet transmission, set the same PVID for a local trunk port and its peer.
To enable a trunk port to transmit packets from its PVID, you must assign the trunk port to the PVID
by using the
port trunk permit vlan command.
Examples
# Configure GigabitEthernet 1/0/1 as a trunk, set its PVID to VLAN 100, and assign it to VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk pvid vlan 100
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 100
Related commands
port link-type
port trunk permit vlan
MAC-based VLAN commands
display mac-vlan
Use display mac-vlan to display MAC-to-VLAN entries.
Syntax
display mac-vlan { all | dynamic | mac-address mac-address [ mask mac-mask ]
| static | vlan vlan-id }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
all: Specifies all MAC-to-VLAN entries.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English