6
Related commands
flow-interval
reset counters interface
display counters rate
Use display counters rate to display traffic rate statistics for interfaces in up state for the most
recent statistics polling interval.
Syntax
display counters rate { inbound | outbound } interface [ interface-type
[ interface-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
inbound: Displays inbound traffic rate statistics.
outbound: Displays outbound traffic rate statistics.
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
Usage guidelines
If you do not specify an interface type, this command displays traffic rate statistics for all up
interfaces that have traffic counters.
If you specify an interface type but do not specify an interface number, this command displays traffic
rate statistics for all up interfaces of the specified type.
If you specify an interface type and an interface, this command displays traffic rate statistics for the
specified interface.
If an interface that you specify is always down for the most recent statistics polling interval, the
system prompts that the interface does not support the command.
To set the statistics polling interval, use the
flow-interval command.
Examples
# Display the inbound traffic rate statistics for all interfaces.
<Sysname> display counters rate inbound interface
Usage: Bandwidth utilization in percentage
Interface Usage (%) Total (pps) Broadcast (pps) Multicast (pps)
GE1/0/1 3 -- -- --
Overflow: More than 14 digits.
--: Not supported.
To Next Page
Loading...
Need help?
General