HPE FlexNetwork 5130 EI Series User Manual

7
Table 2 Command output
Field Description
Interface Abbreviated interface name.
Usage (%)
Bandwidth usage (in percentage) of the interface for the last statistics polling
interval.
Total (pkts/sec)
Average receiving or sending rate (in pps) for unicast packets for the last
statistics polling interval.
Broadcast (pkts/sec)
Average receiving or sending rate (in pps) for broadcast packets for the last
statistics polling interval.
Multicast (pkts/sec)
Average receiving or sending rate (in pps) for multicast packets for the last
statistics polling interval. .
Overflow: more than 14
decimal digits
The command displays
Overflow
if the data length of a statistical item is
greater than 14 decimal digits.
--: not supported The statistical item is not supported.
Related commands
flow-interval
reset counters interface
display ethernet statistics
Use display ethernet statistics to display the Ethernet module statistics.
Syntax
display ethernet statistics slot slot-number
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
slot slot-number: Specifies an IRF member device by its member ID.
Examples
# Display the Ethernet module statistics for the specified slot.
<Sysname> display ethernet statistics slot 1
ETH receive packet statistics:
Totalnum : 10447 ETHIINum : 4459
SNAPNum : 0 RAWNum : 0
LLCNum : 0 UnknownNum : 0
ForwardNum : 4459 ARP : 0
MPLS : 0 ISIS : 0
ISIS2 : 0 IP : 0
IPV6 : 0
ETH receive error statistics:

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English