HPE FlexNetwork 5130 EI Series User Manual

139
Syntax
stp ignore-pvid-inconsistency
undo stp ignore-pvid-inconsistency
Default
Inconsistent PVID protection is enabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only when the device is operating in PVST mode.
Disabling inconsistent PVID protection might cause spanning tree calculation errors. To avoid such
errors, make sure the following requirements are met:
• Make sure the VLANs on one device do not use the same ID as the PVID of its peer port (except
the default VLAN) on another device.
• If the local port or its peer is a hybrid port, do not configure the local and peer ports as untagged
members of the same VLAN.
• Disable inconsistent PVID protection on both the local device and the peer device.
Examples
# In PVST mode, disable the inconsistent PVID protection feature.
<Sysname> system-view
[Sysname] stp mode pvst
[Sysname] stp ignore-pvid-inconsistency
stp log enable tc
Use stp log enable tc to enable the device to log events of detecting or receiving TC BPDUs.
Use
undo stp log enable tc to restore the default.
Syntax
stp log enable tc
undo stp log enable tc
Default
In PVST mode, the device does not generate logs when it detects or receives TC BPDUs.
Views
System view
Predefined user roles
network-admin
Usage guidelines
This command applies only to PVST mode.
Examples
# In PVST mode, enable the device to log events of detecting or receiving TC BPDUs.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English