HPE FlexNetwork 5130 EI Series User Manual

66
Default
ARP fast update is disabled for MAC address moves.
Views
System view
Predefined user roles
network-admin
Examples
# Enable ARP fast update for MAC address moves.
<Sysname> system-view
[Sysname] mac-address mac-move fast-update
mac-address mac-roaming enable
Use mac-address mac-roaming enable to enable MAC address synchronization.
Use
undo mac-address mac-roaming enable to disable MAC address synchronization.
Syntax
mac-address mac-roaming enable
undo mac-address mac-roaming enable
Default
MAC address synchronization is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
On an IRF fabric, if ports on different IRF member devices are Selected ports from the same
aggregation group, MAC address entries are synchronized among these IRF member devices. They
are synchronized whether or not MAC address synchronization is enabled for the IRF fabric. For
more information about aggregation groups, see Layer 2—LAN Switching Configuration Guide.
The MAC address table size might vary by IRF member device. With MAC address synchronization
enabled, MAC address entries exceeding the table size of an IRF member device cannot be
synchronized to the MAC address table.
Examples
# Enable MAC address synchronization.
<Sysname> system-view
[Sysname] mac-address mac-roaming enable
mac-address max-mac-count
Use mac-address max-mac-count to set the MAC learning limit on an interface.
Use
undo mac-address max-mac-count to restore the default.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English