EasyManuals Logo

HPE FlexNetwork 5130 EI Series User Manual

HPE FlexNetwork 5130 EI Series
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
1
Ethernet interface commands
Common Ethernet interface commands
bandwidth
Use bandwidth to set the expected bandwidth of an interface.
Use
undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) is the interface baud rate divided by 1000.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth is an informational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
Examples
# Set the expected bandwidth of GigabitEthernet 1/0/1 to 1000 kbps.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] bandwidth 1000
Related commands
speed
broadcast-suppression
Use broadcast-suppression to enable broadcast suppression and set the broadcast
suppression threshold.
Use
undo broadcast-suppression to disable broadcast suppression.
Syntax
broadcast-suppression { ratio | pps max-pps | kbps max-kbps }
undo
broadcast-suppression

Table of Contents

Other manuals for HPE FlexNetwork 5130 EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5130 EI Series and is the answer not in the manual?

HPE FlexNetwork 5130 EI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5130 EI Series
CategorySwitch
LanguageEnglish

Related product manuals