290
Parameters
delay: Sets the LLDP reinitialization delay in the range of 1 to 10 seconds.
Examples
# Set the LLDP reinitialization delay to 4 seconds.
<Sysname> system-view
[Sysname] lldp timer reinit-delay 4
lldp timer tx-interval
Use lldp timer tx-interval to set the LLDP frame transmission interval.
Use
undo lldp timer tx-interval to restore the default.
Syntax
lldp timer tx-interval interval
undo lldp timer tx-interval
Default
The LLDP frame transmission interval is 30 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Sets the LLDP frame transmission interval in the range of 1 to 32768 seconds.
Examples
# Set the LLDP frame transmission interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20
lldp tlv-enable
Use lldp tlv-enable to configure the types of advertisable TLVs on a port.
Use
undo lldp tlv-enable to disable the advertising of the specified types of TLVs on a port.
Syntax
In Layer 2 Ethernet interface view:
• For nearest bridge agents:
lldp tlv-enable { basic-tlv { all | port-description |
system-capability | system-description | system-name |
management-address-tlv [ ipv6 ] [ ip-address ] } | dot1-tlv { all |
port-vlan-id | link-aggregation | protocol-vlan-id [ vlan-id ] |
vlan-name [ vlan-id ] | management-vid [ mvlan-id ] } | dot3-tlv { all |
mac-physic | max-frame-size | power } | med-tlv { all | capability |
inventory | network-policy [ vlan-id ] | power-over-ethernet |
location-id { civic-address device-type country-code { ca-type
ca-value }&<1-10>
| elin-address tel-number } } }
To Next Page
Loading...
