HPE FlexNetwork 5130 EI Series - Page 299

291
undo lldp tlv-enable { basic-tlv { all | port-description |
system-capability | system-description | system-name |
management-address-tlv [ ipv6 ] [ ip-address ] } | dot1-tlv { all |
port-vlan-id | link-aggregation | protocol-vlan-id | vlan-name |
management-vid } | dot3-tlv { all | mac-physic | max-frame-size | power }
| med-tlv { all | capability | inventory | network-policy [ vlan-id ] |
power-over-ethernet | location-id } }
• For nearest non-TPMR bridge agents:
lldp agent nearest-nontpmr tlv-enable { basic-tlv { all |
port-description | system-capability | system-description |
system-name | management-address-tlv [ ipv6 ] [ ip-address ] } | dot1-tlv
{ all | port-vlan-id | link-aggregation } }
undo lldp agent nearest-nontpmr tlv-enable { basic-tlv { all |
port-description | system-capability | system-description |
system-name | management-address-tlv [ ipv6 ] [ ip-address ] } |
dot1-tlv { all | port-vlan-id | link-aggregation } }
• For nearest customer bridge agents:
lldp agent nearest-customer tlv-enable { basic-tlv { all |
port-description | system-capability | system-description |
system-name |
management-address-tlv [ ipv6 ] [ ip-address ] } |
dot1-tlv { all
| port-vlan-id | link-aggregation } }
undo lldp agent nearest-customer tlv-enable { basic-tlv { all |
port-description | system-capability | system-description |
system-name |
management-address-tlv [ ipv6 ] [ ip-address ] } |
dot1-tlv { all
| port-vlan-id | link-aggregation } }
In Layer 2 aggregate interface view:
lldp agent nearest-nontpmr tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ] [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv { all |
port-vlan-id } }
lldp agent nearest-customer tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ] [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv { all |
port-vlan-id } }
lldp tlv-enable dot1-tlv { protocol-vlan-id [ vlan-id ] | vlan-name
[ vlan-id ] | management-vid [ mvlan-id ] }
undo lldp agent nearest-nontpmr tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ] [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv { all |
port-vlan-id } }
undo lldp agent nearest-customer tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ] [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv { all |
port-vlan-id } }
undo lldp tlv-enable dot1-tlv { protocol-vlan-id | vlan-name |
management-vid }
In IRF physical interface view:
lldp tlv-enable basic-tlv { port-description | system-capability |
system-description | system-name }