HPE FlexNetwork 5130 EI Series User Manual

292
undo lldp tlv-enable basic-tlv { port-description | system-capability |
system-description | system-name }
Default
On Layer 2 Ethernet interfaces:
• Nearest bridge agents can advertise all types of LLDP TLVs except the following types:
{ Location identification TLVs.
{ Port and protocol VLAN ID TLVs.
{ VLAN name TLVs.
{ Management VLAN ID TLVs.
• Nearest non-TPMR bridge agents do not advertise TLVs.
• Nearest customer bridge agents can advertise basic TLVs and IEEE 802.1 organizationally
specific TLVs.
On Layer 2 aggregate interfaces:
• Nearest non-TPMR bridge agents can advertise only EVB TLVs.
• Nearest customer bridge agents can advertise basic TLVs and IEEE 802.1 organizationally
specific TLVs. Among the IEEE 802.1 organizationally specific TLVs, only port and protocol
VLAN ID TLVs, VLAN name TLVs, and management VLAN ID TLVs are supported.
IRF physical interfaces support all available types of TLVs.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
IRF physical interface view
Predefined user roles
network-admin
Parameters
agent: Specifies an LLDP agent type. If you do not specify an agent type in Ethernet interface view,
the command configures the types of advertisable TLVs for nearest bridge agents.
nearest-customer: Specifies nearest customer bridge agents.
nearest-nontpmr: Specifies nearest non-TPMR bridge agents.
all: Advertises all TLVs of the specified type. This keyword enables the interface to advertise
following TLVs:
• All basic LLDP TLVs if the
all keyword is specified for basic-tlv.
• All IEEE 802.1 organizationally specific LLDP TLVs if the
all keyword is specified for
dot1-tlv.
• All IEEE 802.3 organizationally specific LLDP TLVs if the
all keyword is specified for
dot3-tlv.
• All LLDP-MED TLVs except location identification TLVs if the
all keyword is specified for
med-tlv.
basic-tlv: Advertises basic LLDP TLVs.
management-address-tlv [ ipv6 ] [ ip-address | interface loopback
interface-number ]: Advertises management address TLVs. The ipv6 keyword indicates that
the management address to be advertised is in IPv6 format. If you do not specify this keyword, the
management address in IPv4 format will be advertised. The
ip-address argument specifies the

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English