293
management address to be advertised. The interface loopback interface-number option
specifies the management address as the IP address of a loopback interface specified by its number.
By default, the following rules apply:
• When you execute the
lldp tlv-enable command, the management address is the IPv4 or
IPv6 address of the VLAN interface that meets the following requirements:
{ In up state.
{ The corresponding VLAN ID is the lowest among the VLANs permitted on the port.
If you specify the
ipv6 keyword, the management address is the IPv6 address. If you do not
specify the
ipv6 keyword, the management address is the IPv4 address.
If none of the VLAN interfaces of the permitted VLANs is assigned an IPv4 or IPv6 address or
all VLAN interfaces are down, the MAC address of the port will be advertised.
• When you execute the
undo lldp tlv-enable command:
{ If you do not specify ip-address, ipv6, and interface loopback
interface-number, the port does not advertise any management address TLVs.
{ If you specify ip-address, ipv6, or interface loopback interface-number,
the port advertises the default management address TLVs.
port-description: Advertises port description TLVs.
system-capability: Advertises system capabilities TLVs.
system-description: Advertises system description TLVs.
system-name: Advertises system name TLVs.
dot1-tlv: Advertises IEEE 802.1 organizationally specific LLDP TLVs.
port-vlan-id: Advertises port VLAN ID TLVs.
protocol-vlan-id [ vlan-id ]: Advertises port and protocol VLAN ID TLVs. The vlan-id
argument specifies a VLAN ID in the TLVs to be advertised. The VLAN ID is in the range of 1 to 4094,
and the default is the lowest VLAN ID on the port.
vlan-name [ vlan-id ]: Advertises VLAN name TLVs. The vlan-id argument specifies a
VLAN ID in the TLVs to be advertised. The VLAN ID is in the range of 1 to 4094, and the default is the
lowest VLAN ID on the port. If you do not specify a VLAN ID and the port is not assigned to any VLAN,
the PVID of the port is advertised.
management-vid [ mvlan-id ]: Advertises management VLAN ID TLVs. The mvlan-id
argument specifies a management VLAN ID in the TLVs to be advertised. The management VLAN
ID is in the range of 1 to 4094. If you do not specify this option, the value 0 is advertised, which
means that the LLDP agent is not configured with a management VLAN ID.
dot3-tlv: Advertises IEEE 802.3 organizationally specific LLDP TLVs.
link-aggregation: Advertises link aggregation TLVs.
mac-physic: Advertises MAC/PHY configuration/status TLVs.
max-frame-size: Advertises maximum frame size TLVs.
power: Advertises power in MDI TLVs and power stateful control TLVs.
med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory
: Advertises the following TLVs: hardware revision, firmware revision, software revision,
serial number, manufacturer name, model name, and asset ID.
location-id: Advertises location identification TLVs.
To Next Page
Loading...
