196
Related commands
display ip-subnet-vlan interface
display ip-subnet-vlan vlan
ip-subnet-vlan
Protocol-based VLAN commands
display protocol-vlan interface
Use display protocol-vlan interface to display protocol-based VLANs that are
associated with the specified ports.
Syntax
display protocol-vlan interface { interface-type interface-number1 [ to
interface-type interface-number2 ] | all }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number1 to interface-type interface-number2:
Specifies an interface range. Both the
interface-type interface-number1 argument and
the
interface-type interface-number2 argument represent the interface type and
interface number. The value for the
interface-number2 argument must be greater than or equal
to the value for the
interface-number1 argument.
all: Specifies all ports.
Examples
# Display protocol-based VLAN information on GigabitEthernet 1/0/1.
<Sysname> display protocol-vlan interface gigabitethernet 1/0/1
Interface: GigabitEthernet1/0/1
VLAN ID Protocol index Protocol type Status
2 0 IPv6 Active
2 1 N/A Inactive
4094 65535 IPv4 Inactive
Table 42 Command output
Field Description
VLAN ID ID of the protocol-based VLAN.
Protocol index Protocol template index.
Protocol type
Protocol type specified by the protocol template.
This field displays
N/A
if the protocol type is not specified.
To Next Page
Loading...
