EasyManuals Logo

HPE FlexNetwork 5130 EI Series User Manual

HPE FlexNetwork 5130 EI Series
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
98
To prevent packet loss that might occur when a slot reboots, do not enable spanning tree together
with link-aggregation traffic redirection.
Link-aggregation traffic redirection cannot operate correctly on an edge aggregate interface.
Global link-aggregation traffic redirection settings take effect on all aggregation groups. A link
aggregation group preferentially uses the group-specific link-aggregation traffic redirection settings.
If group-specific link-aggregation traffic redirection is not configured, the group uses the global
link-aggregation traffic redirection settings.
As a best practice, enable link-aggregation traffic redirection on aggregate interfaces. If you enable
this feature globally, communication with a third-party peer device might be affected if the peer is not
compatible with this feature.
Examples
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable
link-aggregation load-sharing mode
Use link-aggregation load-sharing mode to set the link-aggregation load sharing mode
for an aggregation group.
Use
undo link-aggregation load-sharing mode to restore the default.
Syntax
link-aggregation load-sharing mode { destination-ip | destination-mac |
source-ip | source-mac } *
undo link-aggregation load-sharing mode
Default
The group-specific load sharing mode is the same as the global load sharing mode.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
destination-ip: Distributes traffic based on destination IP addresses.
destination-mac: Distributes traffic based on destination MAC addresses.
source-ip: Distributes traffic based on source IP addresses.
source-mac: Distributes traffic based on source MAC addresses.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
If an unsupported load sharing mode is set, the device displays an error message.
The following are the link sharing modes supported in aggregate interface view:
• Load sharing mode automatically determined based on the packet type.
• Source IP.
• Destination IP.

Table of Contents

Other manuals for HPE FlexNetwork 5130 EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5130 EI Series and is the answer not in the manual?

HPE FlexNetwork 5130 EI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5130 EI Series
CategorySwitch
LanguageEnglish

Related product manuals