20
full: Configures the interface to operate in full duplex mode. In this mode, the interface can receive
and transmit packets simultaneously.
half: Configures the interface to operate in half duplex mode. In this mode, the interface can only
receive or transmit packets at a given time. Fiber ports, 1000-Mbps Ethernet interfaces, and
10000-Mbps Ethernet interfaces do not support this keyword.
Examples
# Configure GigabitEthernet 1/0/1 to operate in full duplex mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] duplex full
eee enable
Use eee enable to enable Energy Efficient Ethernet (EEE) on an interface.
Use
undo eee enable to disable EEE on an interface.
Syntax
eee enable
undo eee enable
Default
EEE is disabled.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
Fiber ports do not support this command.
With EEE enabled, a link-up interface enters low power state if it has not received any packet for a
period of time. The time period depends on the chip specifications and is not configurable. When a
packet arrives later, the interface restores to the normal state.
Examples
# Enable EEE on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] eee enable
flow-control
Use flow-control to enable TxRx-mode generic flow control on an Ethernet interface.
Use
undo flow-control to disable TxRx-mode generic flow control on the Ethernet interface.
Syntax
flow-control
undo flow-control
To Next Page
Loading...
Need help?
General